ANOTHER GTA TURBO DIES!

Renault & Alpine General Discussion

Moderators: eastlmark, BIG_MVS, phildini, Test Moderator, Alpineandy

no avatar
User

hartgefan5

Rank

Non Member

Posts

3

Joined

Wed Nov 07, 2007 3:45 pm

Location

ayrshire


Has thanked: 0 time
Been thanked: 0 time

ANOTHER GTA TURBO DIES!

Postby hartgefan5 » Mon Feb 11, 2008 12:39 pm

a few weeks ago i introduced myself to you as i had bought a gta to restore,unfortunately i have now got the car back to my workshop and raised up to find that its gone too far!, its very rusty underneath with all wishbones and engine cradle rotten :( ,a fecking shame as its only done 52k i thought it was less but it had a speedo at 23k,it was radbourne racings managing directors car,registered 29th march 1990(one of the last??) in stratos blue with black leather and abs.
it originally came with fagix split rim colour coded alloys which are sadly long gone,car now has the standard alloys.
the chassis no is 42810 in case anyone is keeping a register,i will stick the good parts in the for sale section when i get time,cheers guys
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Postby clee » Mon Feb 11, 2008 12:45 pm

Shame :cry: But how far gone is gone ?Subframe and suspension are all available secondhand at the moment .Are the jacking points OK ?
no avatar
User

hartgefan5

Rank

Non Member

Posts

3

Joined

Wed Nov 07, 2007 3:45 pm

Location

ayrshire


Has thanked: 0 time
Been thanked: 0 time

Postby hartgefan5 » Mon Feb 11, 2008 1:13 pm

its pretty bad,rear drivers side i could pull away with my hand,passengers side is ok??.front jacking points i dont see, is it just the subframe you use? certainly nothing obvious i can see,pointers?.everything metal underneath is corroded i just think it would make sense to start with a better car.opinions welcome
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Postby clee » Mon Feb 11, 2008 4:07 pm

Well the rear is all easily swappable .As long as the turrets are good .Normally they go a little bit N/S where the exhaust manifold runs close .
The jacking point is doable in-situ I'm told .Not sure on the front subframe but again if the turrets are sound ..................
Depends how much time and money you want to put in I suppose :|
You certainly wont get it back :lol:
no avatar
User

scottydog

Rank

Non Member

Posts

151

Joined

Mon Sep 25, 2006 7:35 pm

Location

Bedfordshire.


Has thanked: 0 time
Been thanked: 0 time

Postby scottydog » Mon Feb 11, 2008 9:03 pm

Real shame to see another one broken up. Is it worth offering for sale as a project before breaking it?

I always think it's a great shame that Renault didn't galvanise the chassis. I guess it would have made the cars more expensive though.
User avatar
User

BIG_MVS

Rank

Club Member

Club Member
Posts

5097

Joined

Wed Jun 30, 2004 9:12 am

Location

Sandbach


Has thanked: 38 times
Been thanked: 72 times

Postby BIG_MVS » Mon Feb 11, 2008 9:37 pm

hartgefan5 wrote:its pretty bad,rear drivers side i could pull away with my hand,passengers side is ok??.front jacking points i dont see, is it just the subframe you use? certainly nothing obvious i can see,pointers?.everything metal underneath is corroded i just think it would make sense to start with a better car.opinions welcome


PM sent.

I am travelling up to scotland next week so could take a look at the rust if you want? I have most of the bits you need to get it solid again, let's get it back on the road.................
1994 A610 - Montana Red (For Sale)
User avatar
User

BIG_MVS

Rank

Club Member

Club Member
Posts

5097

Joined

Wed Jun 30, 2004 9:12 am

Location

Sandbach


Has thanked: 38 times
Been thanked: 72 times

Postby BIG_MVS » Sat Feb 23, 2008 10:51 am

Another one for M and S Alpine Restoration :shock:

I went to see it this week, I have never seen a more rotten rear subframe :shock: Poking about with a screwdriver created a shower of rust on the floor :lol: The nearside lower suspension arm was totally not there, it had rotted away!

Anyway Ian doesn't fancy taking on the work so I have bought it. Hopefully the rot is mainly around the rear of the car and I can transfer the rear subframe and suspension from my breaker.

It will keep us busy over spring put it that way.........
1994 A610 - Montana Red (For Sale)
User avatar
User

phildini

Rank

Club Member

Club Member
Posts

1736

Joined

Sun Apr 18, 2004 10:00 am

Location

Epsom Surrey/ Venezia Italy


Has thanked: 7 times
Been thanked: 0 time

Postby phildini » Fri Feb 29, 2008 1:32 pm

BIG_MVS wrote:Another one for M and S Alpine Restoration :shock:

I went to see it this week, I have never seen a more rotten rear subframe :shock: Poking about with a screwdriver created a shower of rust on the floor :lol: The nearside lower suspension arm was totally not there, it had rotted away!

Anyway Ian doesn't fancy taking on the work so I have bought it. Hopefully the rot is mainly around the rear of the car and I can transfer the rear subframe and suspension from my breaker.

It will keep us busy over spring put it that way.........



GO FOR IT SAVE IT !!! SOUNDS LIKE A CAR WITH A GOOD HISTORY
84 R5 Le Car2 Turbo, 95 Clio 16V mk1, 68 Alfa Romeo 1750 GTV, 99 Mitsubishi Evo VI, 06 Porsche Boxster, 11 Lotus Evora S


  • Advertisement

Who is online

Users browsing this forum: No registered users and 257 guests

Powered by phpBB ® | Renault' and 'Alpine' are trademarks of Renault S.A.S. or its subsidiaries and are used with kind permission of Renault France