Clutch problem

Renault & Alpine General Discussion

Moderators: eastlmark, BIG_MVS, phildini, Test Moderator, Alpineandy

no avatar
User

AndyClark

Rank

Non Member

Posts

118

Joined

Sat Dec 11, 2004 11:41 am

Location

Birmingham


Has thanked: 0 time
Been thanked: 2 times

Clutch problem

Postby AndyClark » Sun Jun 27, 2010 9:49 pm

After a run down the motorway this morning (approx 30 miles), the clutch on my atmo (59k) felt odd and very stiff to depress on a couple of occasions while queueing to get into Supercar Sunday at Gaydon. On the way back, things seemed better.

Could it have been the heat? Chris Rabbetts at Roadspeed recently said the clutch was light and gripped well.
no avatar
User

MFaulks

Rank

Non Member

Posts

1552

Joined

Sun Sep 28, 2008 4:25 pm


Has thanked: 45 times
Been thanked: 26 times

Postby MFaulks » Tue Jun 29, 2010 9:50 pm

Andy, no idea, my expertise stops at the flywheel ;-), but some other peeps will probably help, have you joined the club?
... A diamond is only a piece of coal that did well under pressure... PRV afflicted, may be I need to squeeze harder!!!!

https://www.facebook.com/maftecfaulks
no avatar
User

A610beaver

Rank

Non Member

Posts

172

Joined

Fri Jun 13, 2008 10:57 pm


Has thanked: 0 time
Been thanked: 0 time

Postby A610beaver » Sun Jul 04, 2010 9:02 am

This sounds like the problem is on the hyraulic side.

Have you changed the hyraulic fluid in the last couple of years - if not, I'd start there.

If this fixes things short term but then it goes back to being stiff again it could be the master or slave cylinder.
no avatar
User

AndyClark

Rank

Non Member

Posts

118

Joined

Sat Dec 11, 2004 11:41 am

Location

Birmingham


Has thanked: 0 time
Been thanked: 2 times

Postby AndyClark » Mon Jul 12, 2010 9:06 am

The brake fluid is just over a year old. I havent noticed any problems since, so will keep an eye on things over the summer. If anything needs doing, I will get it done over the autumn (along with powder coating the rear subframe)
User avatar
User

stephendell

Rank

Club Member

Club Member
Posts

7463

Joined

Wed Apr 14, 2004 7:25 pm

Location

London


Has thanked: 125 times
Been thanked: 102 times

Postby stephendell » Tue Jul 13, 2010 7:09 pm

If the problem is with the plastic hydraulic lines, we have those in stock.
Trafic, Twingo GT, Vel Satis Turbo x 2, Clio V6 Proto Ph2, Vel Satis 3.5, Avantime, Alpine A610, GTA Atmo x 3, GTA Turbo x 3, R5 Gordini Turbo Mid Engine, Alpine A310 4cyl, Alpine A110, Yellow Smart
User avatar
User

JohnC

Rank

Non Member

Posts

2120

Joined

Sun Dec 02, 2007 6:19 pm

Location

Jersey C.I.


Has thanked: 15 times
Been thanked: 83 times

Re: Clutch problem

Postby JohnC » Tue Jul 13, 2010 8:43 pm

Andy, one question first....when the clutch felt stiff, was it disengaging properly, and were you able to change gear without them crunching?
My first thoughts on this is that it is mechanical, I would check under the pedal cover for a foreign body and clevis pin condition and position etc, (and lubricate the pedal shafts while you are there) and check that the bolts holding the slave cylinder in place have not come loose.
1990 GTA Atmo, 2003 Jaguar X type 2.5SE Auto, 2018 Kia Picanto GT-Line-S 1.25


  • Advertisement

Who is online

Users browsing this forum: Majestic-12 [Bot] and 273 guests

Powered by phpBB ® | Renault' and 'Alpine' are trademarks of Renault S.A.S. or its subsidiaries and are used with kind permission of Renault France