by David Gentleman » Sun May 16, 2004 10:43 am
Also the A610 bumper is higher on the wing line as standard, so when you offer it up to the GTA, it touches the floor. I tried this on my GTA with the spare 610 panels I had. The only way you could do it is to fit a whole 610 front end, the parts are actually quite cheap The bonnet is very slightly longer on the 610, so the original would need filling and adjusting,
the wings would bolt on but the bottom of the GTA wing would need grafting to the 610 wing at the swage line that goes along the car, becuase on the GTA the line bulges inwards and on the 610 it bulges outwards, and the 610 wing has a bit of sideskirt stuck to it at the bottom. All the rest, the wings and nosecone, and bumper would mount together. I was planning to use plexiglass headlamps like on the Le Mans racing 610 rather than the pop ups. Obviously you would have to make up some new mounting brackets to hold the whole front assembly together at the front of the car. The parts worked out about 600 for the nosecone, 150 for each wing, and 400 for the bumper. The only expensive parts where the foglamps at around 400 each! Porsche 928s S4's use the same units, but guess what...the same price!