running problem help!

Renault & Alpine General Discussion

Moderators: eastlmark, BIG_MVS, phildini, Test Moderator, Alpineandy

no avatar
User

rupert

Rank

Non Member

Posts

1323

Joined

Mon Apr 19, 2004 7:39 pm

Location

Plymouth, Devon


Has thanked: 2 times
Been thanked: 9 times

running problem help!

Postby rupert » Sun Nov 06, 2011 7:24 pm

Well I've got a weird running problem.

Take it out for a drive and it's ok, then give the full beans and its fine til probably about 5000 rpm then all power drops, and a big backfire then have to drive it like a nun to get it anywhere, popping and banging if you try to accelerate at all hard.

First I thought it was fuel so I changed the high pressure pump. No difference.

Any ideas, before I head back the the rolling road place.
User avatar
User

Teglen

Rank

Non Member

Posts

254

Joined

Sun Feb 13, 2011 9:23 pm

Location

Near Salisbury, Wiltshire


Has thanked: 2 times
Been thanked: 0 time

Postby Teglen » Sun Nov 06, 2011 8:11 pm

Pops/bangs usually means over fuelling, or by virtue under-ignition (sic)

Check your alternator is charging (14.5 volts min at the battery whilst running)... had exactly same symptoms with mine recently, turned out to be a burnt diode pack on the alternator.
no avatar
User

Alan Moore

Rank

Non Member

Posts

251

Joined

Thu Jul 01, 2004 1:04 pm

Location

Brisbane Australia


Has thanked: 0 time
Been thanked: 4 times

Postby Alan Moore » Mon Nov 07, 2011 4:38 am

I initially thought about the overboost protection, but this will run OK as soon as the boost drops.

I did have a problem some years ago with a new Bremi (Italy) brand distributor cap that after a few months has this sort of siliconnny conductive ooze coming out on the inside and this didn't want to be removed with the normal solvents. Only shifted it with thinners and even then it took time, only for it to reoccur after a couple of months.

I seen this same problem with 4 of these caps on other cars. Just buy the Bosch one for a mid 80s big BMW 6 to save dramas.

The above problem caused my car to miss, but only on boost. Also the seal where the distributor shaft goes into the head can fail causing the cap to fill with engine oil, which usually doesn't help.
GTA V6 Turbo
Renault 4CV 16TS Power
BMW 2002 Tii M3 Power
User avatar
User

simontaylor

Rank

Non Member

Posts

5602

Joined

Thu Apr 15, 2004 12:33 pm

Location

Fleet, Hampshire


Has thanked: 44 times
Been thanked: 56 times

Postby simontaylor » Mon Nov 07, 2011 6:35 am

Rupert has a 24v atmo, his turbo is long gone.
Not sure what ignition system you are running Rupert, but sounds like it has got confused somehow or does not know where TDC is after the back fire. What happens if the Nun stops and restarts the car, which often resets all sorts of ignition componants?
Maybe a carb linkage has popped off and full fuel is being fed in constantly.... til it back fires?
1986 : '86 GTA v6 BW-EFR turbo, with Adaptronic ECU
Firsts at
2007 : Gurston Down & RAOC Champion
2008 : Rushmoor & Eelmoor & ACSMC Hillclimb class Champion
2009 : Longcross & Eelmoor
2010 : Crystal Palace & Eelmoor
2016 : Rushmoor & 5th O/A
User avatar
User

si21

Rank

Non Member

Posts

2094

Joined

Mon May 09, 2005 8:24 pm

Location

S.E London


Has thanked: 3 times
Been thanked: 2 times

Postby si21 » Mon Nov 07, 2011 8:50 am

Teglen wrote:Pops/bangs usually means over fuelling, or by virtue under-ignition (sic)

Check your alternator is charging (14.5 volts min at the battery whilst running)... had exactly same symptoms with mine recently, turned out to be a burnt diode pack on the alternator.


rupert definately check this out you mentioned seperate connections to the alternator recently I hadj similar problems popping banging althouh christine would.not.run below 3000 rpm still worrh.checking all connection.to eliminate I it; it worked for me. Looks likely all the attempts to restart have charred the solenoid contacts and now.the starter wont kick in

Worth.ad look though especialy those seperate connections at the alternator.

si21
User avatar
User

jonc

Rank

Non Member

Posts

382

Joined

Mon Jul 16, 2007 11:08 am

Location

Oxfordshire


Has thanked: 24 times
Been thanked: 6 times

Postby jonc » Mon Nov 07, 2011 1:20 pm

Just to throw another thing to think about into this - it sounds a bit like the A610 known issue, where the car goes into limp-home mode. I think there's still some discussion (and probably variation) as to what the cause is but two that I know of that have resolved this are

- injectors
- ECU overheating.

Of course, this could be completely unrelated but it sounds like something's causing the ECU to lose its mind. Does switching the engine off and re-starting cure anything?
User avatar
User

simontaylor

Rank

Non Member

Posts

5602

Joined

Thu Apr 15, 2004 12:33 pm

Location

Fleet, Hampshire


Has thanked: 44 times
Been thanked: 56 times

Postby simontaylor » Mon Nov 07, 2011 11:40 pm

simontaylor wrote:Rupert has a 24v atmo, his turbo is long gone.


Not sure if he has an ECU ???
1986 : '86 GTA v6 BW-EFR turbo, with Adaptronic ECU
Firsts at
2007 : Gurston Down & RAOC Champion
2008 : Rushmoor & Eelmoor & ACSMC Hillclimb class Champion
2009 : Longcross & Eelmoor
2010 : Crystal Palace & Eelmoor
2016 : Rushmoor & 5th O/A
User avatar
User

simonsays74

Rank

Non Member

Posts

1296

Joined

Thu Apr 15, 2004 10:12 pm

Location

Belfast (££££ Zone!!)


Has thanked: 0 time
Been thanked: 0 time

Postby simonsays74 » Sun Nov 20, 2011 10:21 pm

simontaylor wrote:
simontaylor wrote:Rupert has a 24v atmo, his turbo is long gone.


Not sure if he has an ECU ???


Emerald ECU


  • Advertisement

Who is online

Users browsing this forum: No registered users and 243 guests

Powered by phpBB ® | Renault' and 'Alpine' are trademarks of Renault S.A.S. or its subsidiaries and are used with kind permission of Renault France