Rear windscreen connectors

Both my heated rear screen connectors have departed from their positions on the screen.
Can anyone recommend a good conductive epoxy to stick them back on?

By the way, I haven't run my GTA without the engine cooling cover before, but I have a 'squeak' at the rear and by process of elimination I wanted to rule out the cover.
No cover makes a difference on the noise front doesn't it didn't realise how much it suppresses it.

If the copper strip is still on the screen then solder them back on it is possible i did it on my car

Or you can use conductive glue (the stuff with silver particles in it). I used that before and then reinforced it over the top with some glue & tape.

You might be able to solder if you're good and use some flux, but the glass tends to act as a massive heatsink so it's not as easy as all that.

I've still got some silver glue. I was going to fix Jon Viola's for him. Pop round Jon when you get a mo.

This sort of stuff. http://www.amazon.co.uk/ELECTRO-CONDUCT ... B006UJGB7Q

They sell it in Halfords and Maplins also.

I've used this Frost Fighter stuff in the past. Works a treat.
http://www.frostfighter.com/index.htm

That looks very good. Where do you get it from in the uk?

Got them direct from the internet a few years ago.

I went for the kit http://www.frostfighter.com/defroster-repair-tab-bonding-kit-2000.htm and they shipped directly pretty quickly.

Jon