GTA bellhousing

I did have two but let them go Typical .
Anyone ?

[BIG_MVS]

You plonka! Only got one with the box attached

Didn't one go on ebay recently?

Lee, if you're not using the CAS, you can fit a DeLorean one - swap for yer modded flywheel?

If it's the same basic shape/form then yes please ,it's a swap .

Identical apart from the sensor mount.

Rob W's coming past you on his way home sometime shortly after crimbo, can get him to collect/drop off if you like? The bellhousing I have is all bead blasted and purdy, on a rebuilt box that needs the sensor in it now...

That'd be good

Hi not sure if you are still on the hunt for a bell housing but I have one for sale and some other parts as well.Use the link below to veiw pictures
I will put the bell housing pictures on for you asap.

http://s267.photobucket.com/albums/ii30 ... lt_Alpine/

Tel/Txt Tim 07810 320464.

Hi Tim ,

All sorted now but thanks .Are you one of the fast-bus boys ? I sold a few un1 boxes to some lads down your way a while back .

Was at WSR Donington a few years ago I remember ?

The very same one!
Back on the road in the spring, when all the nasty road salt has washed away! Great fun to drive, alegedly 200bhp???

I had pondered the idea of doing that on a bay... did you use the GTA rear subframe?

Thanks for the bellhousing by the way Martin Just the job .

I had pondered the idea of doing that on a bay... did you use the GTA rear subframe?

I dropped the engine and box out of the car in one unit.
Then I did the same on the VW
The next job was to put the Renault engine and gearbox under the van on a clarks motor bike jack.
I lowered the van down and cut out any parts that got in the way inc the original boot floor, inner wings, bulkhead and and area under the back seat to allow the gearbox nose cone to fit.
Then I made up all the new sheet metal, an engine cradle and a new gearbox mount.
All very simple now it is finished, but lots of time was lost deciding how to go about all the individual tasks.
The only extra work on the bay is the cooling system, but that has all been done by other builders, covered in other forums such as vwkd.

lovin your work fella, cool!