chargecooler

well im half way there in fitting the chargecooler the rad/fan are mounted the chargecooler is mounted just got to do the pipe run and a bit of wiring,ive also mounted the chargecooler on the left hand side and not on top of the engine and on the way home i was putting my foot down quite a bit and when i touched the cooler it was just warm not very hot like the old v6 boost pipe so im very pleased with that ive also had the dumpvalve moved so it sits next to the throttle body now but apart from that it looks very very bling
will post sum pics asap

Aiiiiiiiiiiiiiiiiiii
Are you blinging it to Brunters

yeah hopefully lee depending on work think im going down friday eveing then camping which should be a laugh should be a top wkend though

Just on with the rad, Is it poss to reverse the fan so it will push air instead of pulling it through Any ideas

http://www.renaultalpineownersclub.com/ ... php?t=1616

yeah hopefully lee depending on work think im going down friday eveing then camping which should be a laugh should be a top wkend though

Hope to see you and the GT Blinger there I've bought a track/strip pass Would be good to see two GTA's (if not more ,DG ,others )ragging round in a sea of 5s

Just on with the rad, Is it poss to reverse the fan so it will push air instead of pulling it through Any ideas

Yeah, turn the whole rad and fan round...

I was pretty sure it was a pusher anyway

Did you follow all the instructions for fitting I gave you? Make sure all that air is out of the cooler, and the filler is the highest point at all times, and that the water from the cool side of the pre-rad is flowing into the 'cold' end of the chargecooler.

Couldnt use my bling boost pipe need to order some silicone hose, anyway work in progress
[img][img]http://i30.photobucket.com/albums/c314/leylandracer/cc00.jpg[/img][/img]

Dave, Iv got the cc rad mounted in front of the radiator with the cc fan pushing air in i hope

Somthing strange Just been around the block after moving the dump valve (as on picture) & its over boosting, surly that shouldnt make a difference ill swop it back after tea when its cooled down.

Couldnt use my bling boost pipe need to order some silicone hose, anyway work in progress
[img][img]http://i30.photobucket.com/albums/c314/leylandracer/cc00.jpg[/img][/img]

WTF is that sticker on the rear glass blinger I don't think it's in keping wiv da image innit .
Nice layout though

gt5, where does the hose from the end of the DV go to? I think it needs to go to the inlet manifold, but yours looks like it is going in the other direction.

That is some route you have for the CC.

Moved the dv back & its still over-boosting, Got the pipework done yesterday, so it looks like its the diferent routing of the CC

Check for leaks ,just had mine overboosting after a move about, it was a small split in the hose to the actuator .