Moderators: eastlmark, BIG_MVS, phildini, Test Moderator, Alpineandy
Non Member
1514
Tue Apr 12, 2005 12:24 am
Nr Chippenham, Wiltshire
Non Member
1514
Tue Apr 12, 2005 12:24 am
Nr Chippenham, Wiltshire
Non Member
3474
Thu Apr 15, 2004 8:10 am
Colchester, Essex
Stunned Monkey wrote:The ATMO engine and DeLorean engine are identical apart from the atmo uses carbs and the DeLorean uses K-Jet injection. The ignition system is identical. Even the coil is in roughly the same place in the engine bay.
Non Member
1514
Tue Apr 12, 2005 12:24 am
Nr Chippenham, Wiltshire
David Gentleman wrote:
...and apart from the cams, heads, pistons, compression ratio, lower crankcase, rocker covers etc.....
Non Member
1514
Tue Apr 12, 2005 12:24 am
Nr Chippenham, Wiltshire
Ohms_GTA wrote:
just not sure if it needs a ballast resistor or whether there's even one in the standard set up.
Non Member
3474
Thu Apr 15, 2004 8:10 am
Colchester, Essex
Stunned Monkey wrote:David Gentleman wrote:
...and apart from the cams, heads, pistons, compression ratio, lower crankcase, rocker covers etc.....
Pedant.
What does any of that have to do with ignition ? The engine is internally identical apart from slightly higher domes on the pistons (CR). Cams and heads are identical apart from the K-Jet injector ports. The crank case is identical apart from the mounts being 2" further back. In fact the Renault manual actually shows an R30/DeLorean crank case.
Okay, the rocker covers are different. The DeLorean actually has stuff mounted to them.
NO PRV is absolutely identical across two cars that I can think of, if you want to be pedantic. Not even the R25 turbo and GTA.... Safrane and Laguna..... Espace and R25..... Volvo 760 and 260...... XM 24v and 605 24v....
Non Member
1514
Tue Apr 12, 2005 12:24 am
Nr Chippenham, Wiltshire
Users browsing this forum: No registered users and 261 guests