3 way catch tank connector.

for a 1986 turbo, I need the 3 way connector that links inlet manifold, oil catch tank and air intake. It sits just above the oil breather/catch-tank.

It is item 10 on page 13.341 of the parts manual.

I know there is a special valve in the manifold pipe, item 2, but can I just connect the manifold to the catch tank as a temperary measure?

Of cource I'll be trying a stealer in the morning, but dont often have much luck with them.

for a 1986 turbo, I need the 3 way connector that links inlet manifold, oil catch tank and air intake. It sits just above the oil breather/catch-tank.

It is item 10 on page 13.341 of the parts manual.

I know there is a special valve in the manifold pipe, item 2, but can I just connect the manifold to the catch tank as a temperary measure?

Of cource I'll be trying a stealer in the morning, but dont often have much luck with them.

email me the part no and i may be able to get one here for you..... collection .... macon

Andy, that would be great, 60 00 007 678 and it is for a 1986 GTA turbo, but dont bust a gut for it, or spend too much, it is only a little bit of plastic, worth a few quid or 10 euros.
It is a 3 way connector where each union is 90 degrees to the other 2.
Local stealer says "BO".

Make one?

Make one?

i bet he never thought of that....

Make one?

no choice..... you'll have to make one

part doesn't exist anymore

LOL

Bin the catch tank , plug the sump and get a later filler cap styley one ...Or I can try and find one in the jun..classic car parts bin

For now, I have installed a breather filter onto the top of the catch tank.
I have also left the manifold pipe loose, as it does have the valve (1 way ?) in the end of it.
Mind you, there are fumes coming from the breather filter..... but will live with that for now.
If you have a later filler cap, that could be mighty usefull.

You can buy a new oil filer cap with two outlets to fit an Alpine from HALFORDS for £2 ..49 part no HOC 610 Then bin the oil catch tank

Turbodog = topdog,
a fix for an Alpine for less than a cost of a beer. FANTASTIC

Top-dog Turbodog, it fits a treat. Just need to plumb it in now.

Lee, what is the size of the 1 way valve on the inlet manifold, I wish to replace the pipe from it to my new oil breather, and I need to know the bore size. The one from the manifold valve that used to go the catch tank, ie part 7 on page 13.431 of the parts manual.

I dont want to take off the existing one yet, it looks fragile and prone to damage, and I need the car for prescott and the Palace this weekend.

Thanks in advance.