Breaking 1988 GTA ATMO

[BIG_MVS]

Ed has had it on the ramp and had a good poke around, it's not good news unfortunately (chassis rot) so it's another breaker.

All parts available. Good bits:

Black Leather Seats with later folding rear seats

Both headlamp glasses intact but Near Side has a small crack

Good Rear Lamps

Both wing mirrors good

Good Standard alloys with good tyres

All body panels good but Red paint faded

Gearbox good, engine has slight top end knock

etc etc

PM or call me - 07768 728980

http://www.youtube.com/watch?v=CWsJcg-g1pg

I think they might want to change the first word ....

back in the game

Near side door mirror please!

[BIG_MVS]

Sold to the irish man!

Other bits which are good:

Front bonnet undertray
Battery/Scuttle Cover (not great but alot better than a few I have seen!)
Spare wheel and cover/Jack
2 brand new Rear Calipers fitted shortly before going off the road
Original Stereo
All binicle, speedo, trip comp etc
Interior trim, centre console and switches all good
Very Good Steering Wheel

engine bay wiring?

[BIG_MVS]

OK lots sold, still got the following left:

Set of alloys in good condition with tyres.

Full Black Leather Interior with later rear folding seats

ATMO Clockset/computer

ATMO Engine and Box

Driveshafts

Rear Subframe ATMO (also have a turbo one available)

Front Nosecone

Doors

Bonnet

Rear Engine Cover with decent carpet

Gear Lever and rods

Fuel Tank

Headlights

Indicator/Wash wipe stalks

Most of the glass, good windscreen and rear screen.

[BIG_MVS]

Also got:

Set of OE dark grey/black overmats (drivers slightly worn)

Map/Interior Lamp (perfect)

Handbrake and Gearstick Gaitors (good condition)

Front Load Cover Gas Struts

[BIG_MVS]

Interior lamp sold, Bonnet gone too.

[phildini]

Interior lamp sold, Bonnet gone too.

Hope you have not forgotten me MR MVS.......

[BIG_MVS]

Nope Don Phildini

All interior panels minus the lamp and plip reciever wasn't it? Oh and the engine bay "Scoops". Owt else?

Hi

When the vehicle is striped of parts, whats going to happen to the tub (is it still in one piece).

Derek

[BIG_MVS]

We usually cut the back end out of it to get the engine and box out.

What do you plan to do with it? We could drop the guts out of the bottom and avoid and cutting of the rear end if you wanted it?

Me again BIG_MVS,
do you have the fuel flow consumpsion unit (sits on the right side just foward of the ingintion coil.
Regards Rodney

[BIG_MVS]

Yes Rodney I have, again PM me.