high idle

Renault & Alpine General Discussion
User avatar
User

mogster242

Rank

Non Member

Posts

556

Joined

Mon Apr 19, 2010 9:13 pm

Location

Bournemouth


Has thanked: 20 times
Been thanked: 6 times

high idle

Postby mogster242 » Sun Oct 09, 2011 10:22 pm

Hi all,

My GTA turbo has been behaving real nice recently :D (after a bad summer) which means that i have enjoyed some nice drives in this late summer weather :D :D

however, the last week or so it has started to idle higher than normal (about 1500rpm as opposed to just under 1000rpm) when the engine is warm. it also runs quite rich and uses a lot of petrol... when the engine is cold its runs perfectly... :shock: :?

any ideas? thanks
Cedric
1989 GTA V6 Turbo Grey
Megane R26 F1
Clio 197
User avatar
User

simontaylor

Rank

Non Member

Posts

5602

Joined

Thu Apr 15, 2004 12:33 pm

Location

Fleet, Hampshire


Has thanked: 44 times
Been thanked: 56 times

Postby simontaylor » Sun Oct 09, 2011 10:57 pm

could be the fuel regulator..... or a pipe that has come off it or perished/split? Maybe???
1986 : '86 GTA v6 BW-EFR turbo, with Adaptronic ECU
Firsts at
2007 : Gurston Down & RAOC Champion
2008 : Rushmoor & Eelmoor & ACSMC Hillclimb class Champion
2009 : Longcross & Eelmoor
2010 : Crystal Palace & Eelmoor
2016 : Rushmoor & 5th O/A
User avatar
User

mogster242

Rank

Non Member

Posts

556

Joined

Mon Apr 19, 2010 9:13 pm

Location

Bournemouth


Has thanked: 20 times
Been thanked: 6 times

Postby mogster242 » Mon Oct 10, 2011 8:24 am

I had to replace the return hose from the left hand bank to the regulator few weeks ago coz was leaking... its now a bit longer than the original to made sure it does not kink
1989 GTA V6 Turbo Grey
Megane R26 F1
Clio 197
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Postby clee » Mon Oct 10, 2011 12:04 pm

Water temp sensor .
The one on the LHS of the pump .Check resistance relative to temp.
Take it out and leave to stablise for a while .Then pop it in a pan with a thermometer ....or just hit it with a heatgun and see what it does ...
20 degree 283 to 297
80 degree 383 to 397
90 degree 403 to 417
User avatar
User

darrenbiggs

Rank

Non Member

Posts

1499

Joined

Thu Apr 29, 2004 1:03 pm

Location

Horley - Nr Gatwick


Has thanked: 15 times
Been thanked: 39 times

Postby darrenbiggs » Mon Oct 10, 2011 12:40 pm

Also (sounds silly I know) but check the throttle is returning fully.

The pulley under the plenum can foul on the main water hose and restrict the movement. I had this happen and it only occured when hot, basically the water hose would expand when hot and under pressure and the small pin on the pulley would sometimes catch and not let the throttle close totally back to idle.

Fixed with a cable tie around the hose.
I'm just here for the gasoline.
User avatar
User

mogster242

Rank

Non Member

Posts

556

Joined

Mon Apr 19, 2010 9:13 pm

Location

Bournemouth


Has thanked: 20 times
Been thanked: 6 times

Postby mogster242 » Mon Oct 10, 2011 12:57 pm

Clee,

I will check that... do you have a picture showing the sensor? I suppose if the resistance doesnt change then it means that the sensor is knackered?

Darren,

the throttle cable shows signs of tiredness.. lots of strands are broken between the pulley and the end of the cable sleeving. I am planning to replace the cable and Mr Dell is looking if he has a replacement one in stock....... (Renault leadtimes are over a month for the cable.... )
i looked if the broken strands were not stopping the cable to return but didnt look at the water hose, so will check that too

thanks you guys
1989 GTA V6 Turbo Grey
Megane R26 F1
Clio 197
User avatar
User

jonc

Rank

Non Member

Posts

382

Joined

Mon Jul 16, 2007 11:08 am

Location

Oxfordshire


Has thanked: 24 times
Been thanked: 6 times

Postby jonc » Mon Oct 10, 2011 5:10 pm

Definitely worth checking the throttle. Make sure that it is opening and closing freely. Many years ago the mechanism on mine went a bit sticky. No fun having a stuck throttle but really easy to fix with a bit of teflon spray lube or the like
User avatar
User

darrenbiggs

Rank

Non Member

Posts

1499

Joined

Thu Apr 29, 2004 1:03 pm

Location

Horley - Nr Gatwick


Has thanked: 15 times
Been thanked: 39 times

Postby darrenbiggs » Mon Oct 10, 2011 5:37 pm

Also (and I had this before), check the throttle return in the footwell.

Take the plastic cover from around the pedal box out and spray the pedals with WD40, remove all the gunk and crud, then relube with lithium grease or similar.

It's unlikely to be the fix (unless the pedal feels overly stiff) but you'd be surprised, and being floor hinged they to tend to trap dirt. If nothing else when you get the other problem fixed you'll have lovely smooth moving accelerator, brake and clutch!
I'm just here for the gasoline.
User avatar
User

mogster242

Rank

Non Member

Posts

556

Joined

Mon Apr 19, 2010 9:13 pm

Location

Bournemouth


Has thanked: 20 times
Been thanked: 6 times

Postby mogster242 » Mon Oct 10, 2011 8:47 pm

Image

Image

Image

Image

looks like a great connection there :shock: as soon as i tried to separate both parts of the connector, the wire snapped :evil: so i trimmed it and soldered it back in place :oops: as i couldnt get the pin out...

i checked the resistance when engine cold 288 ohms and when warm 390 ohms. so it looks like the sensor works.

still idles high though............. :(

checked the throttle again and it seems to move nicely, plenty clearance

pedals are moving nicely too, i have already cleaned that recently...

:? [/img]
1989 GTA V6 Turbo Grey
Megane R26 F1
Clio 197
User avatar
User

BIG_MVS

Rank

Club Member

Club Member
Posts

5097

Joined

Wed Jun 30, 2004 9:12 am

Location

Sandbach


Has thanked: 38 times
Been thanked: 72 times

Postby BIG_MVS » Mon Oct 10, 2011 9:02 pm

Idle Control Valve getting stuck when warm???
1994 A610 - Montana Red (For Sale)
User avatar
User

mogster242

Rank

Non Member

Posts

556

Joined

Mon Apr 19, 2010 9:13 pm

Location

Bournemouth


Has thanked: 20 times
Been thanked: 6 times

Postby mogster242 » Mon Oct 10, 2011 9:06 pm

where is this located? what can i do to check if it works ok?
1989 GTA V6 Turbo Grey
Megane R26 F1
Clio 197
User avatar
User

BIG_MVS

Rank

Club Member

Club Member
Posts

5097

Joined

Wed Jun 30, 2004 9:12 am

Location

Sandbach


Has thanked: 38 times
Been thanked: 72 times

Postby BIG_MVS » Mon Oct 10, 2011 9:09 pm

On top of the left hand bank/rocker cover.

Image

Give it a good clean out using carb cleaner or such like.
1994 A610 - Montana Red (For Sale)
User avatar
User

Teglen

Rank

Non Member

Posts

254

Joined

Sun Feb 13, 2011 9:23 pm

Location

Near Salisbury, Wiltshire


Has thanked: 2 times
Been thanked: 0 time

Postby Teglen » Mon Oct 10, 2011 10:02 pm

Search on here for IACV... mine went just as I was buying the car (but got the garage to replace before i signed). I then remember coming across a thread on here that explained the logic behind it's operation... and also a step by step diagnosis.
User avatar
User

jon_viola

Rank

Non Member

Posts

1159

Joined

Sun Oct 22, 2006 8:45 pm

Location

Sussex


Has thanked: 4 times
Been thanked: 7 times

Postby jon_viola » Mon Oct 10, 2011 10:04 pm

Mine had this problem a while back. The next thing is it will start flooding and or backfiring.

Change your engine temps sensor as Lee suggests. Your close on your readings but not spot on and its a sensitive area- if I remember correctly around £30 from Renault :D :wink:
1989 GTA Turbo
2003 Mercedes E320 CDI Estate- A.K.A Badke Bus

www.badkequartet.co.uk
User avatar
User

mogster242

Rank

Non Member

Posts

556

Joined

Mon Apr 19, 2010 9:13 pm

Location

Bournemouth


Has thanked: 20 times
Been thanked: 6 times

Postby mogster242 » Mon Oct 10, 2011 10:10 pm

did changing the temp sensor solve the problem for you?
1989 GTA V6 Turbo Grey
Megane R26 F1
Clio 197
Next


  • Advertisement

Who is online

Users browsing this forum: Google Adsense [Bot] and 257 guests

Powered by phpBB ® | Renault' and 'Alpine' are trademarks of Renault S.A.S. or its subsidiaries and are used with kind permission of Renault France