GTA Stainless water pipes

I need to order at least one pair from Simon so would anyone else like in on a set ? Might not get a big discount ,dependent on volume ,but you will save a lot on the shipping .
previous thread

http://www.renaultalpineownersclub.com/ ... =stainless

.
If it works out at better than 20% off, I'll have a set. I don't pay the 19% euro VAT, so if better than that, it's worth it init

Cheers,
Martin

4 takers so far .I need to get these on order early next week so will check with Andreas on poss discount .

RATS
MoFo
Rupret
Dave W
???

[stephendell]

Don't forget to order the heater return pipe as well this time!

I didn't forget ....nobody asked ...100 euro or so more .Seemed a bit steep relative to ..

Do I need any Clee?

[stephendell]

I didn't forget ....nobody asked ...100 euro or so more .Seemed a bit steep relative to ..

We ordered a couple up and can confirm they are identical to RHD. seems a lot of work to only replace 2 of 3 rusty pipes to save £100 and then to have to go back and replace the third one (engine out again etc). Maybe give people the option, personally I think they would be crazy not to change them all. Same metal, same car, same coolant, same level of corrosion? But then when people are buying seals, bushes and decal in singles rather than pairs you may be fighting a losing battle!

Maybe the smaller ones don't corrode as much? What have been the state of any you have looked at?

Just had a look at the old steel pipes that came off the A310. I'd say the amount of corrosion was probably similar for the large and small pipes but because the smaller pipes were originally less wall thickness than the larger pipes, there's less metal left on these pipes.

4 takers so far .I need to get these on order early next week so will check with Andreas on poss discount .

RATS
MoFo
Rupret
Dave W
???

Lee, I am in Nottingham in September...... and can bring parts south if needed.
And can take stuff north too.

? ?

Thanks Simon ,will be in touch .

As to the small pipe .Most seem fine and although 100 is not much in the grand scheme it all does add up and sometimes you have to make a judgement .
I regularly have 4/5k parts bills ( incl weld bill ) on a single car so you can see why .The small pipe can be bypassed ,taken out the circuit if needed so nowhere near as critical as the mains .The heater side of things normally ends with failure of the matrix and dash out ......
But yes ....I would say if you have the new batch then perhaps think long and hard about adding the smaller and then you will be 100% .

Lee, I will be going up to Nottingham on the evening of the 7th and returning on the evening of the 9th October.
If anyone else wants bits taken up to lee or collected.
Will be using the M3, M25 and M1.

I will be putting an order in soon for these + other bits .
Can I have firm takers on this please + if anyone wants other bits I can add them to order and should save on post at the very least .I'm sure I can swing a bit of a discount as well

Will order early next month .