Spark plugs & misfire

Renault & Alpine General Discussion

Moderators: eastlmark, BIG_MVS, phildini, Test Moderator, Alpineandy

User avatar
User

paulrob100

Rank

Non Member

Posts

383

Joined

Sat May 02, 2015 9:20 pm

Location

Nottingham


Has thanked: 6 times
Been thanked: 12 times

Spark plugs & misfire

Postby paulrob100 » Thu May 21, 2015 7:45 pm

Hi guys

My car has been suffering from a slight misfire as the engine speed increases from idle. I decided to change the plugs, The ones fitted were NGK BP7EFVX. To be fair they looked ok when I removed them. The new plugs are NGK BKUR7ET. These plugs seem to have the same reach however when fitting them they did not seem to screw in as far. I counted about 7 turns before they became tight, whereas the old ones needed about 12 turns to remove them. Am I missing something, or is this because the plug seats are different. Most of all is this ok.? I don't want to do any damage. Unfortunately the misfire is still there. I am going to try new plug leads next.

Thanks Paul
La Plastique Fantastique :GTA
User avatar
User

BIG_MVS

Rank

Club Member

Club Member
Posts

5097

Joined

Wed Jun 30, 2004 9:12 am

Location

Sandbach


Has thanked: 38 times
Been thanked: 72 times

Re: Spark plugs & misfire

Postby BIG_MVS » Thu May 21, 2015 9:19 pm

Moved from Website help.

Paul - The website help section is for website issues rather than car stuff.

As for the misfire how are the HT Leads looking? Are they old? I seem to remember someone saying run the car in the dead of night (pitch black) with the engine cover open and see if there are any electrical currents showing up which will tell you if the plug leads have had it.
1994 A610 - Montana Red (For Sale)
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Re: Spark plugs & misfire

Postby clee » Thu May 21, 2015 9:32 pm

New plugs are A610 not GTA .Old plugs I put in about 200 miles ago so should be OK :Mass
User avatar
User

paulrob100

Rank

Non Member

Posts

383

Joined

Sat May 02, 2015 9:20 pm

Location

Nottingham


Has thanked: 6 times
Been thanked: 12 times

Re: Spark plugs & misfire

Postby paulrob100 » Thu May 21, 2015 11:06 pm

Thanks Lee. I didn't think they looked old.

Paul
La Plastique Fantastique :GTA
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Re: Spark plugs & misfire

Postby clee » Fri May 22, 2015 6:38 am

I'd take the 610 ones out .Will check dims when in unit but they are taller and the GTA has domed piston ,610 flat .
User avatar
User

paulrob100

Rank

Non Member

Posts

383

Joined

Sat May 02, 2015 9:20 pm

Location

Nottingham


Has thanked: 6 times
Been thanked: 12 times

Re: Spark plugs & misfire

Postby paulrob100 » Fri May 22, 2015 10:26 am

Thanks Lee, I have already taken them out. Don't want to do any damage :up
La Plastique Fantastique :GTA
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Re: Spark plugs & misfire

Postby clee » Fri May 22, 2015 10:40 am

Good.I've just popped some in a GTA head and it wouldn't have hit as perversely they don't protrude enough .Shoulder diameter is a lot bigger and bottoms well before the probes enter the chamber .That why you get less turns.Will take some pics .If you want to pop over just shout and we can do some tests,swap leads etc to track it down .
User avatar
User

clee

Rank

Non Member

Posts

10431

Joined

Fri May 28, 2004 11:58 am

Location

Derbyshire


Has thanked: 54 times
Been thanked: 104 times

Re: Spark plugs & misfire

Postby clee » Fri May 22, 2015 11:37 am

WP_20150522_004.jpg

WP_20150522_005.jpg

WP_20150522_006.jpg
You do not have the required permissions to view the files attached to this post.
User avatar
User

paulrob100

Rank

Non Member

Posts

383

Joined

Sat May 02, 2015 9:20 pm

Location

Nottingham


Has thanked: 6 times
Been thanked: 12 times

Re: Spark plugs & misfire

Postby paulrob100 » Fri May 22, 2015 9:22 pm

That's great lee, thanks for taking the time. I want to come over but although I am retired, having recently moved house, the list of jobs goes on. Added to which, we are going away next weekend. Hopefully I will get a chance to come over before we go.

Paul
La Plastique Fantastique :GTA


  • Advertisement

Who is online

Users browsing this forum: No registered users and 150 guests

Powered by phpBB ® | Renault' and 'Alpine' are trademarks of Renault S.A.S. or its subsidiaries and are used with kind permission of Renault France