Knocking clutch pedal

Renault & Alpine General Discussion

Moderators: eastlmark, BIG_MVS, phildini, Test Moderator, Alpineandy

no avatar
User

mikegta

Rank

Non Member

Posts

27

Joined

Sat Jun 12, 2004 2:27 am

Location

Bristol way


Has thanked: 0 time
Been thanked: 0 time

Knocking clutch pedal

Postby mikegta » Wed Aug 24, 2005 9:27 pm

Last time I went out for a spin I noticed an ever so slight knocking, tapping feedback on the cluth pedal as I depress it. Today I went out and it seems worse and is just about audible.

Seems to go after the car is warmed up. Any ideas and will I have to raid the Christmas fund?
User avatar
User

chris

Rank

Non Member

Posts

96

Joined

Thu Apr 14, 2005 10:31 am

Location

Melbourne , Australia


Has thanked: 0 time
Been thanked: 0 time

clutch

Postby chris » Sun Aug 28, 2005 12:58 am

May be the clutch master cylinder spring breaking . Try depressing the pedal with your hand and see how quickly it returns.
User avatar
User

simontaylor

Rank

Non Member

Posts

5602

Joined

Thu Apr 15, 2004 12:33 pm

Location

Fleet, Hampshire


Has thanked: 44 times
Been thanked: 56 times

Postby simontaylor » Sun Aug 28, 2005 11:39 am

Also check the clutch linkage, on the pedal.

There is a silly set up of a clip and 2 plastic washers that act as a bearing between the pedel and the linkage. These plastic washers go brittle, break and then the pedal acts directly on the pin, which begins to wear. You will then notice some free play in the clutch pedel.

by hand (but not when driving) move the clutch pedel back and forth and see where you have free play.

I think on my car the return spring is/has gone as the connecting rod does not return into the cylinder fully. I've yet to see how easy it is to get the cylinder off, to check the spring.
1986 : '86 GTA v6 BW-EFR turbo, with Adaptronic ECU
Firsts at
2007 : Gurston Down & RAOC Champion
2008 : Rushmoor & Eelmoor & ACSMC Hillclimb class Champion
2009 : Longcross & Eelmoor
2010 : Crystal Palace & Eelmoor
2016 : Rushmoor & 5th O/A
no avatar
User

mikegta

Rank

Non Member

Posts

27

Joined

Sat Jun 12, 2004 2:27 am

Location

Bristol way


Has thanked: 0 time
Been thanked: 0 time

Postby mikegta » Sun Aug 28, 2005 7:31 pm

Thanks for suggestions. I'm pretty sure I've tracked it down to a thrust bearing. Had a look in the workshop manual, not too big a job?


  • Advertisement

Who is online

Users browsing this forum: Google Adsense [Bot] and 194 guests

Powered by phpBB ® | Renault' and 'Alpine' are trademarks of Renault S.A.S. or its subsidiaries and are used with kind permission of Renault France