A110 Group 4/5

As you are working with weight savings ...... will this be a competition car to use?

[stephendell]

That's the plan if it ever gets finished lol.

Excellent News, keep up the good work.

Amazing car and the color

Anyone else had any experience with A110 screens?

Not yet but I will have later in the year, after the car comes back from the paint shop.

I've removed the screens and the front seal could possibly be reused, especially after reading your comments about your new seal. The rear seal will need replacing. Where did you obtain yours from?

[stephendell]

Both seals came from Dieppe in the final parts run

Thanks, the usual sources for mine then.

[stephendell]

No going back now!

181157DE-0715-48A8-8DD3-61E367E409C3.jpeg

3384B2E1-F502-4848-A0FA-F747A58E98DA.jpeg

5B975286-8C70-4B63-981D-B00AC63B0184.jpeg

C43CFBA2-3988-48CA-9C04-7908E0522B32.jpeg

EED648C4-91C4-4258-8534-54AE01E7F271.jpeg

Amazing how much of the original arches is cut away. They must have allowed for a lot of suspension travel...

[stephendell]

Trial fitting new radiator

382B9DEE-A1DC-4735-BB32-BC626A5E219C.jpeg

[stephendell]

Trial fit of new radiator fans in the original 6” size

F25EE7B8-4A9D-485E-8341-E8447D94EF09.jpeg

0D9B1FB9-AC55-43AE-9B35-CC74E69822CE.jpeg

[stephendell]

Spent a lot of time repairing, tidying and repainting the front compartment in yacht enamel.

A pretty unpleasant job that I wouldn’t want to do again any time soon.

DECE7E66-053E-422C-B22B-E72D19BD175E.jpeg

43BFD8C4-3891-4D43-A2C4-A5059EF53AD0.jpeg

Getting there Stephen. I'll be Painting the inside of mine in a couple of weeks as the paint job is nearly complete.

Did you cut the hole over the steering rack/front suspension or was it like that when you acquired it? Certainly makes access easier for chassis painting and assembly. Does it have a cover?

Is the green webbing restraint a temporary measure until you fit the spring clip at the front of the bonnet. Or is the fuel tank between the seats and engine?

[stephendell]

Weirdly the Access hole was only cut over about 75%. I removed the brake fluid reservoirs and cut it evenly so it was symmetrical. It is great for access. I will make up an aluminium cover.

The green is a bit of a colour clash with the orange but it works quite well. Will probably change it for Black. Yes tank is in the back on mine so not much to go back in here, rad and fans, brake fluid bottles and battery. There is currently not heater fan so may fit something for a little forced ventilation.

Agreed about the strap, I think black would look better.

Is that your Lithium battery in the first photo of the July 11th post?

I notice you went for yellow for the front suspension wishbones. I also went for colour when they were powder coated.

[stephendell]

Nice

Yes that’s the lithium battery, not convinced they have sufficient cranking capacity though.