who does modified cams?

hi guys ive just found your forum, im in Australia, and wondering if anybody can point in the direction of where i can get cams for a 3 liter v6, ive been reading some older threads on here, and im looking at going the way of the 3lt conversion as i have a few old laguna B56R engines sitting about,
(that im going to put 11.1 pistons in) i already have throttle bodies (that i will have to make a new manifold for the 3 liter) and aftermarket injection on the alpine,
im wanting to build something that puts out around the 270 to 300 hp
have any on here achieved this?
im also going to need larger piped extractors, does anybody know where these can be brought ??

regard paul.

2.5L with BW EFR 6258 turbo, 440cc injectors, PWR 10 inch Charge Cooler, and Adaptronic ECU and A610 clutch.
Std block, heads, cams, manifolds and a straight through exhaust.
Running 280bhp and 300 ftLbs.

.
Hi Paul,

Drop me a pm, and I will put you in touch with a guy in Australia who took my data for a n/a cam profile that I had cut, will do what you need, he thn got it cut locally (Auz) and is running it now (has dyno data). You can then make contact, compare notes, and I'm sure he can get some more ground for you.

Regards
Martin

thanks guys, i want this to stay non turbo, as i want it to look as original as possible.. well closeish..

2.5L with BW EFR 6258 turbo, 440cc injectors, PWR 10 inch Charge Cooler, and Adaptronic ECU and A610 clutch.
Std block, heads, cams, manifolds and a straight through exhaust.
Running 280bhp and 300 ftLbs.

11:1 Compression so don't think it will turbo :0).

I don't know of anybody who has tuned an aspirated GTA virtually at all in this country. I know MoFo did quite a high power build for a kit car but I think this was around 230 bhp if I remember rightly. A few 310s around in France running powerful atmo builds but I think 100 bhp litre from this engine might be a push at any budget, the engine just isn't that efficient.